Service manual

Section III: Buffer
Installation 1-19
1.2.4 Aligning the Buffer Carriage
This procedure is performed after the buffer is attached to the imagesetter.
1. Remove the buffer top cover.
2. Bring the carriage to the front (toward the imagesetter) of the buffer. Hold
the carriage tightly against the frame.
If both ends of the carriage are flush against the frame, nothing else is
required.
If the carriage is not flush, go to Step 3.
3. For older buffers:
a. Remove the four (4) screws in the braces on the left and right hand side
of the buffer. Refer to Figure 1-17. Lift the braces off.
Figure 1-17 Older buffer brace.
➀–End brace. ➁–Four end brace screws (two each side).
1
2
2