Service manual

Avantra 36/44 Service Manual
3-22 Removal and Replacement
Figure 3-18 Dryer assembly (from the rear).
➀–Dryer assembly. ➁–Element mounting screws.
➂–Rear element mounting bolts. ➃–Dryer element.
7. From the rear, remove the two (2) element mounting bolts. Refer to
Figure 3-18.
8. From the front, remove the two (2) element mounting screws. Refer to
Figure 3-18.
9. Using a small flathead screwdriver, remove the three (3) corresponding
wires from the terminal block at the front of the plate. Refer to Figure 3-17.
CAUTION: Note the wire numbering for proper replacement.
Replace:
1. Reverse the order of the removal procedures above being careful to seat
the wires in their proper places.
1
3
2
4