Service manual

Avantra 36/44 Service Manual

1-6 Mounting

9. Install the stop pin through the base of the boom, which extends below

the mount. Refer to Figure 1-5. Make sure that the head of the stop pin is

on the same side as the control switches.

The locking pin locks the boom in place once the set screws have been

tightened against the adapter. Make sure the locking pin is facing straight

out as shown before tightening the set screws. Note that the adapter has

recesses for the set screws.

Figure 1-5 Mounting the boom into the adapter/mount.

➀

–Spring loaded locking pin.

➁

–Boom.

➂

–Adapter.

➃

–Four mounting plate bolts with washers

➄

–Mounting bracket.

➅

–Two allen set screws in mount.

➆

–Stop pin.

➇

–Lock block with bolt.