Service manual

Avantra 36/44 Service Manual
2-10 Removal and Replacement
2.2.4 Crane Cable
Tools Required: phillips head screwdriver, flat head screwdriver, 9/64" hex
wrench, pliars
Remove:
1. Using the up/down switch, lower the crane cable as far as possible.
2. Using a phillips head screwdriver, remove the four (4) screws on the front
and back cover of the head.
3. Disconnect the power cable at each end of the head.
4. Using a flat head screwdriver, remove the three (3) screws in the end stop
at the front of the boom. Figure 1-6.
5. Carefully roll the head off the boom rails. Figure 1-6. Lay the head down
on a flat surface with the top (open) end up.
6. Using a 9/64" hex wrench, remove the four (4) hex screws at the top of the
head. This Detaches The Motor Assembly.
CAUTION:
While removing the screws, support the motor at the
cable end.
7. Pull the cable and hook up through the hole in the head.
8. Spread the sides of the head and slide the head assembly free.