Technical data

Chapter 1 17
Installation and Setup
Safety Information
Installation and Setup
WARNING The front panel switch is a standby switch only; it is not a LINE
switch (power disconnecting device).
WARNING Install the product so that the detachable power cord is readily
identifiable and easily reached by the operator. The detachable
power cord is the product disconnecting device. It disconnects
the mains circuits from the mains supply before other parts of
the product. The front panel switch is only a standby switch
and is not a LINE switch. Alternatively, an externally installed
switch or circuit breaker (which is readily identifiable and is
easily reached by the operator) may be used as a disconnecting
device.
WARNING Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended. Discard
used batteries according to manufacturer’s instructions.
WARNING No operator serviceable parts inside. Refer servicing to
qualified personnel. To prevent electrical shock do not remove
covers.
WARNING Servicing instructions are for use by qualified personnel only.
To avoid electrical shock, do not perform any servicing unless
you are qualified to do so.
The opening of covers or removal of parts is likely to expose
dangerous voltages. Disconnect the product from all voltage
sources while it is being opened.
Adjustments described in the service manual are performed
with power supplied to the analyzer while protective covers are
removed. Energy available at many points may, if contacted,
result in personal injury.
CAUTION If you are charging the batteries internally—even while the analyzer is
powered off—the analyzer may become warm. Take care to provide
proper ventilation.
CAUTION To avoid overheating, always disconnect the analyzer from the external
power supply before storing the analyzer in the soft carrying case.
If you prefer to leave the analyzer connected to the external power
supply while inside the soft carrying case, you can disconnect the
external power supply from its power source to prevent overheating.