Agilent 16048B Test Leads Operating Note Third Edition Agilent Part No.
Notices The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright.All rights are reserved. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of the Agilent Technologies. Agilent Technologies Japan, Ltd. Component Test PGU-Kobe 1-3-2, Murotani, Nishi-Ku, Kobe-shi, Hyogo, 651-2241 Japan Copyright © Agilent Technologies Japan, Ltd.
• Keep Away From Live Circuits Operating personnel must not remove instrument covers. Component replacement and internal adjustments must be made by qualified maintenance personnel. Do not replace components with the power cable connected. Under certain conditions, dangerous voltages may exist even with the power cable removed. To avoid injuries, always disconnect power and discharge circuits before touching them.
Technologies from another country. Agilent Technologies warrants that its software and firmware designated by Agilent Technologies for use with an instrument will execute its programming instruction when property installed on that instrument. Agilent Technologies does not warrant that the operation of the instrument, or software, or firmware will be uninterrupted or error free.
MANUAL CHANGES Agilent 16048B MANUAL IDENTIFICATION Model Number: 16048B Date Printed: May 2000 Part Number: 16048-90012 Test Leads Operating Note This supplement contains information for correcting manual errors and for adapting the manual to newer instruments that contains improvements or modifications not documented in the existing manual. To use this supplement 1. Make all ERRATA corrections 2.
1 General Information Introduction This operation note provides the information for operating and maintaining the HP 16048B Test Leads. Description The HP 16048B is a direct attachement, 4-terminal pair type xture which is equipped with four SMC(f) terminated coaxial test leads. These test leads are used to attach user-fabricated test xtures to the instruments.
Speci cation Connector Type Cable Length Weight SMC (female) Approximately 1 meter (39.4 inches) 250 grams (0.55 lbs) :::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::: :::::::::::::::::::::::::::::::::::::::::::::: ::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::: Operation Setup and measurement procedure 1. Connect the HP 16048B directly to the UNKNOWN terminals of the instrument. 2. Connect the user-fabricated test xture to the test leads. 3.
2 Maintenance Maintenance principally consists of cleaning contacts and replacing worn or damaged parts. Figure 2-1 shows the HP 16048B replaceable parts. Only the parts whose part numbers are in the parts list are replaceable. Use the correct Hewlett-Packard part number when ordering replaceable parts. Table 2-1. Replaceable Parts List Reference HP Part Description Designator Number Qty.
Figure 2-1.
REGIONAL SALES AND SUPPORT OFFICES For more information about Agilent Technologies test and measurement products, applications, services, and for a current sales office listing, visit our web site: http://www.agilent.com/find/tmdir. You can also contact one of the following centers and ask for a test and measurement sales representative. 11/29/99 United States: Agilent Technologies Test and Measurement Call Center P.O.
