Installation guide

Installing Logic Analyzer Cards and Probes 2
16900 Series Logic Analysis Systems Installation Guide 53
16911A/10A Logic Analyzer (1-card module)
Each card shipped stand- alone has the 2 x 15 cable connected in the
single- card module configuration. The 2 x 50 cables in the accessory
pouch are not used. A single- card module can be installed in any available
slot.
The order of pods on the 16910A logic analyzer card’s rear panel is:
The order of pods on the 16911A logic analyzer card’s rear panel is:
In a multi- card set, pods are indexed starting with the master card, then
with the expander cards from the bottom up.
NOTE
Turn off the mainframe power before removing, replacing, or installing modules. For
instructions on installing modules into the logic analysis system frame, refer to page 26.
Pods 3 and 4 Pods 5 and 6 Pods 1 and 2
Pods 3 and 4 Pods 1 and 2