Manualshelf

Installation guide

ManualsBrandsAgilent Technologies ManualsComputer equipment16700 SERIES LOGIC ANALYSIS SYSTEM 16700
21222324252627282930
21
Chapter 2: Connecting and Configuring Hardware
To configure an optional monitor for the 16702B
To configure an optional monitor for the 16702B
The internal LCD display is pre-configured for 800 x 600 at the factory. Use
this procedure if you wish to configure an external monitor or change the
monitor setting to a different resolution.
1 Connect your monitor to the logic analysis system as shown on page 18.
2 Turn on power to the monitor and then to the logic analysis system.
3 Immediately press the TAB key. Press once per second for
approximately 30 seconds. The display will change on the screen every
few seconds as the system cycles through the monitor resolution
choices.
1
2