Specifications

113

Chapter 1: Agilent Technologies 16700A/B-Series Logic Analysis System

Run/Group Run Function

Using Run - Run All - Group Run

The Run/Stop functions are initiated by selecting icons in the icon bar

at the top of the tool windows. All instrument, display, and analysis tool

windows will have one of the Run icons shown below to initiate the run

function.

When two or more instrument tools are configured, they can be run

either independently or as a group. If run in a group, it is called an

Intermodule measurement. Use the Intermodule Window (see the

Agilent Technologies 16700A/B-Series Logic Analysis System help

volume) to coordinate the arming in a "Group Run". A common "Group

Run" configuration is to configure one instrument to trigger and then

arm another instrument to start evaluation of its own trigger condition.

The Run Single icon appears if you have a single instrument

configured in your measurement and you want to run a single

acquisition.

The Run All icon always appears in the System, Workspace and

Run Status windows. Also appears in instrument and display windows

when you are using multiple instruments in your measurement and

these instruments ARE NOT configured in an intermodule

measurement (Group Run). This choice runs a single acquisition on all

instruments in the configuration.

The Group Run icon appears in all windows when you are using

multiple instruments, and these instruments are configured into a

Group Run. This choice runs a single acquisition on all instruments in

the Group Run configuration.

The Run Repetitive icon appears in all windows. It is used to run a

Run Single, Run All, and a Group Run acquisition repetitively. The

current run mode will continue to run until Cancel is selected.