Technical data

CALCulate Subsystem 3

N1911A/1912A P-Series Power Meters Programming Guide 177

CALCulate[1]|2|3|4:LIMit:FAIL?

This query enters a 1 or 0 into the output buffer indicating whether there

have been any limit failures for the specified window. A limit failure is

defined as CALC[1]|2|3|4:LIMit:FCO? being non- zero. The FCO (fail

counter) can be zeroed using the CALC[1]|2|3|4:LIMit:CLEar command.

• 1 is returned when one or more limit failures have occurred

• 0 is returned when no limit failures have occurred

Syntax

Example

Reset Condition

On reset, the buffer is set to zero for both upper and lower window

measurements.

CALC1:LIM:FAIL? This command queries if there have been

any limit failures on the upper

window/upper measurement.

:LIM

:FAIL

CALC