Technical data

DISPlay Subsystem 5

N1911A/1912A P-Series Power Meters Programming Guide 243

DISPlay[:WINDow[1]|2]:SELect[1]|2

This command is used to select a specific measurement within a specific

window.

If the second numeric value is not sent, the upper measurement of the

relevant window is selected. This command is used to specify which

measurement is used for the analog, trace, or single numeric display.

Syntax

Example

Reset Condition

On reset, the upper window upper measurement is selected.

Query

DISPlay[:WINDow[1]|2]:SELect[1]|2?

The query enters a 1 or 0 into the output buffer indicating whether the

window specified is currently selected.

DISP:WIND2:SEL1 This command selects the upper

measurement in the lower window.

:SEL 1

:WIND

DISP