Technical data

PSTatistic Subsystem 9

N1911A/1912A P-Series Power Meters Programming Guide 311

PSTatistic:CCDF:GAUSsian:MARKer[1]|2[:SET]

This command is used to set the markers on Gaussian trace. The markers

will be set only if the trace is present and visible. According to the

selections made, the markers will become active on the screen.

Syntax

Example

Reset Condition

On reset, the marker is set on the next visible trace according to the

sequence Channel A, Channel B, Reference or Gaussian.

NOTE

This command is only applicable when P-Series sensors are present and the following

conditions are met:

• Free-run acquisition mode is selected

• NORMal or DOUBle measurement speed setting is chosen

• Expanded window is enabled (not full CCDF screen window)

:MARK

PST

:CCDF :GAUS

:SET

PST:CCDF:GAUS:MARK This command sets marker 1 on the

Gaussian trace.