Technical data

PSTatistic Subsystem 9

N1911A/1912A P-Series Power Meters Programming Guide 349

PSTatistic[1]|2:CCDF:TRACe:MARKer[1]|2[:SET]

This command is used to set the marker on Channel A or Channel B

trace. The markers will be set only if the trace is present and visible.

According to the selections made, the markers will become active on the

screen.

Syntax

Example

Reset Condition

On reset, the marker will be set on the next visible trace according to the

sequence Channel A, Channel B, Reference or Gaussian.

NOTE

This command is only applicable when P-Series sensors are present and the following

conditions are met:

• Free-run acquisition mode is selected

• NORMal or DOUBle measurement speed setting is chosen

• Expanded window is enabled (not full CCDF screen window)

:MARK

:CCDF

:TRAC

:SET

PST

PST:CCDF:TRAC:MARK This command sets the marker1 on

Channel A.

PST2:CCDF:TRAC:MARK2 This command sets the marker2 on

Channel B.