Technical data

10 SENSe Subsystem
382 N1911A/1912A P-Series Power Meters Programming Guide
Example
Query
[SENSe[1]]|SENSe2:BUFFer:COUNt?
This query is used to retrieve the average or peak measurement buffer
size.
Query Example
On Reset
On *RST, the value is set to 1.
Error Messages
• If no sensor or wrong sensor is connected to the channel, error –241,
“Hardware missing” occurs.
• If E4410, N8480, E9300, E9320 or N1920 sensor is connected but
acquisition mode is in free run, error –221, “Setting conflict. Invalid
acquisition mode” occurs.
• If frequency sweep step is non- zero, error –221, “Settings conflict.
Frequency sweep enabled. Buffer count overidden” occurs.
BUFF:COUN 100 This command sets the average or peak
measurement buffer size to 100 for
Channel A.
BUFF:COUN? This query returns the average or peak
measurement buffer size for Channel A.