Technical data

1 Power Meter Remote Operation
32 N1911A/1912A P-Series Power Meters Programming Guide
If you have retained the original data in a program, edit the program and
resend the data.
Selecting a Frequency Dependent Offset Table
After you have created the frequency dependent offset table, you can
select it using the following command:
[SENSe[1]]|SENSe2:CORRection:CSET2[:SELect] <string>
To find out which frequency dependent offset table is currently selected,
use the query:
[SENSe[1]]|SENSe2:CORRection:CSET2[:SELect]?
Enabling a Frequency Dependent Offset Table
To enable the frequency dependent offset table, use the following
command:
[SENSe[1]]|SENSe2:CORRection:CSET2:STATe ON
If you set [SENSe[1]]|SENSe2:CORRection:CSET2:STATe to ON and no
frequency dependent offset table is selected error –221, “Settings conflict”
occurs.
Making the Measurement
To make the power measurement, set the power meter for the frequency of
the signal you want to measure. The power meter automatically sets the
calibration factor. Use either the INITiate, FETCh? or the READ? query to
initiate the measurement as shown in the following program segments:
INITiate Example
ABORt1
CONFigure1:POWer:AC DEF,1,(@1)
SENS1:CORR:CSET2:SEL "Offset1"