Technical data

TRIGger Subsystem 14

N1911A/1912A P-Series Power Meters Programming Guide 661

TRIGger[1]|2[:IMMediate]

This command causes a trigger to occur immediately, provided the

specified channel is in the wait for trigger state. When this command is

executed, the measurement result is stored in the power meter’s memory.

Use FETCh? to place the measurement result in the output buffer.

TRIGger[1]|2:DELay:AUTO is ignored if TRIGger[1]|2[:IMMediate] is

set to ON.

Syntax

Example

Error Messages

If the power meter is not in the wait for trigger state, then

TRIGger:IMMediate causes error –211, “Trigger ignored”.

NOTE

This command performs the same function as INITiate[1]|2:[IMMediate].

TRIG This command causes a Channel A trigger

to occur immediately.

TRIG

:IMM