Technical data

16 SERVice Subsystem

730 N1911A/1912A P-Series Power Meters Programming Guide

SERVice:SENSor[1]|2:RADC?

This query returns a new raw uncorrected measurement in volts, as a 32

bit signed integer.

Syntax

Example

Error Messages

•If INIT:CONT is set to ON, error –221 “Settings Conflict” occurs.

• If the E9320 Series or P- Series sensor is connected and

SERVice:SENSor[1]|2:CORRections:STATe is set to ON, error –221

“Settings Conflict” occurs.

NOTE

For E9320 Series and P-Series sensors:

Before running this query, the voltage to corrected power conversion must be disabled

using the SERVice:SENSor[1]|2:CORRections:STATe command.

SERV:SENS2:RADC? This query returns a new raw

uncorrected measurement for the sensor

connected to Channel B.

:RADC

SERV

:SENS