Technical data

What's New 1
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 27
Changed
Commands
:SEARch:SERial:IIC
Commands (see page 542)
Commands for finding IIC events in the captured data.
:SEARch:SERial:LIN
Commands (see page 549)
Commands for finding LIN events in the captured data.
:SEARch:SERial:SPI
Commands (see page 555)
Commands for finding SPI events in the captured data.
:SEARch:SERial:UART
Commands (see page 559)
Commands for finding UART/RS232 events in the captured
data.
:SEARch:STATe (see page 535) Enables or disables the search feature.
:TRIGger:LEVel:ASETup (see
page 595)
Sets the trigger levels of all displayed analog channels to their
waveforms' 50% values.
Command Differences
Command Differences
:BLANk (see page 158) You can now use the SBUS1 source parameter to turn off the
serial decode display.
:DIGitize (see page 159) You can now use the SBUS1 source parameter to acquire the
serial waveform.
:SAVE:WAVeform:FORMat
(see page 440)
The ALB format is no longer supported.
:STATus (see page 179) You can now use the SBUS1 source parameter to view the serial
decode display status.
:SYSTem:MENU (see
page 569)
The LISTer parameter is now available.
:VIEW (see page 182) You can now use the SBUS1 source parameter to turn on the
serial decode display.
:WAVeform:SOURce (see
page 649)
Can select SBUS1 as the waveform source.
:WAVeform:SOURce:SUBSour
ce (see page 653)
With the SPI and UART/RS232 serial decode options,
subsources are now valid in the 2000 X-Series oscilloscopes.