Technical data

296 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
17 :HARDcopy Commands
Introduction to
:HARDcopy
Commands
The HARDcopy subsystem provides commands to set and query the
selection of hardcopy device and formatting options such as inclusion of
instrument settings (FACTors) and generation of formfeed (FFEed).
:HARDC is an acceptable short form for :HARDcopy.
Reporting the Setup
Use :HARDcopy? to query setup information for the HARDcopy subsystem.
Return Format
The following is a sample response from the :HARDcopy? query. In this
case, the query was issued following the *RST command.
:HARD:APR "";AREA SCR;FACT 0;FFE 0;INKS 1;PAL NONE;LAY PORT
:HARDcopy:NETWork:PAS
Sword <password> (see
page 306)
n/a <password> ::= quoted ASCII
string
:HARDcopy:NETWork:SLO
T <slot> (see
page 307)
:HARDcopy:NETWork:SLO
T? (see page 307)
<slot> ::= {NET0 | NET1}
:HARDcopy:NETWork:USE
Rname <username> (see
page 308)
:HARDcopy:NETWork:USE
Rname? (see page 308)
<username> ::= quoted ASCII
string
:HARDcopy:PALette
<palette> (see
page 309)
:HARDcopy:PALette?
(see page 309)
<palette> ::= {COLor | GRAYscale
| NONE}
n/a :HARDcopy:PRINter:LIS
T? (see page 310)
<list> ::= [<printer_spec>] ...
[printer_spec>]
<printer_spec> ::=
"<index>,<active>,<name>;"
<index> ::= integer index of
printer
<active> ::= {Y | N}
<name> ::= name of printer
:HARDcopy:STARt (see
page 311)
n/a n/a
Table 67 :HARDcopy Commands Summary (continued)
Command Query Options and Query Returns