Technical data

What's New 1
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 35
Command Differences From 7000B Series Oscilloscopes
The Agilent InfiniiVision 2000 X- Series oscilloscopes command set is most
closely related to the InfiniiVision 7000B Series oscilloscopes (and the
7000A Series, 6000 Series, and 54620/54640 Series oscilloscopes before
them).
The main differences between the version 1.00 programming command set
for the InfiniiVision 2000 X- Series oscilloscopes and the 6.10 programming
command set for the InfiniiVision 7000B Series oscilloscopes are related
to:
• Built- in waveform generator (with Option WGN license).
• Built- in demo signals (with Option EDU license that comes with the
N6455A Education Kit).
• Reference waveforms (in place of trace memory).
• Serial decode is not supported.
• Waveform event search is not supported.
• Smaller set of trigger types.
• Fewer measurements.
• Different path name format for internal and USB storage device
locations.
More detailed descriptions of the new, changed, obsolete, and discontinued
commands appear below.
New Commands
Command Description
:DEMO Commands (see
page 237)
Commands for using built-in demo signals (with the Option EDU
license that comes with the N6455A Education Kit).
:HARDcopy:NETWork
Commands (see page 295)
For accessing network printers.
:MEASure:WINDow (see
page 376)
When the zoomed time base in on, specifies whether the
measurement window is the zoomed time base or the main time
base.
:MTESt:ALL (see page 382) Specifies whether all channels are included in the mask test.
:RECall:WMEMory<r>[:STARt]
(see page 423)
Recalls reference waveforms.
:SAVE:WMEMory:SOURce
(see page 444)
Selects the source for saving a reference waveform.
:SAVE:WMEMory[:STARt]
(see page 445)
Saves reference waveforms.