Technical data

514 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide

25 :SBUS<n> Commands

:SBUS<n>:UART:BITorder

(see page 790)

Command Syntax

:SBUS<n>:UART:BITorder <bitorder>

<bitorder> ::= {LSBFirst | MSBFirst}

The :SBUS<n>:UART:BITorder command specifies the order of transmission

used by the physical Tx and Rx input signals for the serial decoder and/or

trigger when in UART mode. LSBFirst sets the least significant bit of each

message "byte" as transmitted first. MSBFirst sets the most significant bit

as transmitted first.

Query Syntax

:SBUS<n>:UART:BITorder?

The :SBUS<n>:UART:BITorder? query returns the current UART bit order

setting.

Return Format

<bitorder> ::= {LSBF | MSBF}

See Also • "Introduction to :TRIGger Commands" on page 589

• ":TRIGger:MODE" on page 598

• ":SBUS<n>:UART:TRIGger:TYPE" on page 529

• ":SBUS<n>:UART:SOURce:RX" on page 522

• ":SBUS<n>:UART:SOURce:TX" on page 523