Technical data

:SEARch Commands 26
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 541
:SEARch:SERial:CAN:PATTern:ID:MODE
(see page 790)
Command Syntax
:SEARch:SERial:CAN:PATTern:ID:MODE <value>
<value> ::= {STANdard | EXTended}
The :SEARch:SERial:CAN:PATTern:ID:MODE command specifies whether a
standard ID value or an extended ID value is used when searching for a
CAN event.
The ID value is specified using the :SEARch:SERial:CAN:PATTern:ID
command.
Query Syntax
:SEARch:SERial:CAN:PATTern:ID:MODE?
The :SEARch:SERial:CAN:PATTern:ID:MODE? query returns the current
setting.
Return Format
<value><NL>
<value> ::= {STAN | EXT}
See Also • Chapter 26, “:SEARch Commands,” starting on page 531
• ":SEARch:SERial:CAN:MODE" on page 537
• ":SEARch:SERial:CAN:PATTern:ID" on page 540