Technical data

:WAVeform Commands 30

Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 639

:WAVeform:FORMat

(see page 790)

Command Syntax

:WAVeform:FORMat <value>

<value> ::= {WORD | BYTE | ASCii}

The :WAVeform:FORMat command sets the data transmission mode for

waveform data points. This command controls how the data is formatted

when sent from the oscilloscope.

• ASCii formatted data converts the internal integer data values to real

Y- axis values. Values are transferred as ASCii digits in floating point

notation, separated by commas.

ASCII formatted data is transferred ASCii text.

• WORD formatted data transfers 16-bit data as two bytes. The

:WAVeform:BYTeorder command can be used to specify whether the

upper or lower byte is transmitted first. The default (no command sent)

is that the upper byte transmitted first.

• BYTE formatted data is transferred as 8- bit bytes.

When the :WAVeform:SOURce is the serial decode bus SBUS1, ASCii is the

only waveform format allowed.

When the :WAVeform:SOURce is one of the digital channel buses (BUS1 or

BUS2), ASCii and WORD are the only waveform formats allowed.

Query Syntax

:WAVeform:FORMat?

The :WAVeform:FORMat query returns the current output format for the

transfer of waveform data.

Return Format

<value> ::= {WORD | BYTE | ASC}

See Also • "Introduction to :WAVeform Commands" on page 629

• ":WAVeform:BYTeorder" on page 635

• ":WAVeform:SOURce" on page 649

• ":WAVeform:DATA" on page 637

• ":WAVeform:PREamble" on page 644

Example Code • "Example Code" on page 650