Technical data

:WGEN Commands 31

Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 691

:WGEN:VOLTage:OFFSet

(see page 790)

Command Syntax

:WGEN:VOLTage:OFFSet <offset>

<offset> ::= offset in volts in NR3 format

The :WGEN:VOLTage:OFFSet command specifies the waveform's offset

voltage or the DC level. Use the :WGEN:VOLTage command to specify the

amplitude.

You can also specify the amplitude and offset indirectly using the

:WGEN:VOLTage:HIGH and :WGEN:VOLTage:LOW commands. For example,

an amplitude of 5 V and an offset of 1 V is the same as a high- level

voltage of 4 V and a low-level voltage of - 1 V.

Query Syntax

:WGEN:VOLTage:OFFSet?

The :WGEN:VOLTage:OFFSet? query returns the currently specified

waveform offset voltage.

Return Format

<offset> ::= offset in volts in NR3 format

See Also • "Introduction to :WGEN Commands" on page 665

• ":WGEN:FUNCtion" on page 667

• ":WGEN:VOLTage" on page 688

• ":WGEN:VOLTage:HIGH" on page 689

• ":WGEN:VOLTage:LOW" on page 690