User`s guide

2-2 User’s and Service Guide

Getting Started

Connecting and Turning on the Test Set

The test set is designed to be placed underneath the network analyzer

in a rack system and connected to it as shown in Figure 2-1. Use the

two SMA 50 Ω jumper cables, part number 08720-20245, that were

shipped with the test set. See Table 1-1 on page 1-3.

Figure 2-1 Connecting the Test Set to the Network Analyzer

After all the proper connections have been made, turn on the test set

using the front panel line switch. The front panel line switch

disconnects the mains circuits from the mains supply after the EMC

filters and before other parts of the instrument.

NOTE For accurate, repeatable measurements, be sure to let the test set warm

up for at least 2 hours. It is recommended that the test set not be

turned off on a regular basis. For the most stable and accurate

measurements, leave the test set turned on at all times.