User`s guide

4-6 User’s and Service Guide
Front and Rear Panels
Power Cables
Power Cables
The line power cable is supplied in one of several configurations,
depending on the destination of the original shipment.
Each instrument is equipped with a three-wire power cable. When
connected to an appropriate ac power receptacle, this cable grounds the
instrument chassis. The type of power cable shipped with each
instrument depends on the country of destination. See Figure 4-5 on
page 4-7 for the part numbers of these power cables. Cables are
available in different lengths. Check with your nearest Agilent
Technologies service center for descriptions and part numbers of cables
other than those described in Figure 4-5. See “Contacting Agilent
Technologies” on page 7-6.
CAUTION Always use the three-prong ac power cord supplied with this product.
Failure to ensure adequate grounding by not using this cord may cause
damage to the product.
WARNING This is a Safety Class I product (provided with a protective
earthing ground incorporated in the power cord). The mains
plug shall only be inserted in a socket outlet provided with a
protective earth contact. Any interruption of the protective
conductor, inside or outside the instrument, is likely to make
the instrument dangerous. Intentional interruption is
prohibited.