Specifications

6-15

Replacing Assemblies

To remove the keyboard assembly

1 Remove the front panel.

2 Remove all of the knobs by pulling them straight out.

3 Using the T10 TORX driver, remove the four screws from the keyboard

shield.

4 Lift the ribbon cable end of the small keyboard and simultaneously slide

the small keyboard toward the main keyboard to remove.

Figure 6-12

Removing the keyboard assembly

CAUTION USE CORRECT SCREWS TO AVOID DAMAGING FRONT PANEL

LABEL!

When you re-install the keyboard, you must re-insert the screws you removed

in this step. If you re-insert screws that are longer, they can damage the front

panel label.

5 Lift the keyboard assembly straight out.

service.book Page 15 Wednesday, August 28, 2002 3:25 PM