Specifications

6-9
Replacing Assemblies
To remove the display
4
Use a flat-blade screwdriver to gently unhook the latch that holds the
white power-actuator shaft to the power switch, then disconnect the
shaft from the power switch. After you disconnect the shaft, make sure
you position it in the recess along the side of the display bracket.
Figure 6-6
Unhooking the power switch shaft
5 Lift the display and remove it from the deck.
6 When reinserting the power shaft, push the shaft into the power switch
until the shaft seats.
Gently apply outward
pressure at this corner
of the slot
service.book Page 9 Wednesday, August 28, 2002 3:25 PM