Specifications

waveform
Menu
The
waveform
menu has four available memories,
m! m2, m3,
and
m4.
These
memories
are
nonvolatile and will not
be deared
during
AUTOSCALE,
RECALL
CEAR, or
recycling
power.
This
permits
disconnection
of
power
u16 6ansportion of the
oscilloscope without
losing
the
contents
of
waveform memories.
A waveform
memory
consists
of a single waveform record
hsluding
the
horizontal
and vertical
scaling
parameters.
This
allows measurements
on
previously
stored waveform
and
function
data. Voltage
and time markers
can
be set
on waveforms when
they are displayed however,
the time
markers
follow
the TIMEBASE
menu
time/division
and not
that
of the
memorywaveform.
When
the HP
54510A is in the envelope
display
mode
and
a
waveform
store is
executed,
the
minimum value
and maximum value
are
stored
separately.
The
minimum value will
be stored in mL if ml
or m3 are the
selected
store locations,
or
m2
if
-?
or
m4
are
the storage locations. The
ma:rimum
values
are
stored
in m3 or m4 respectively.
A
store
message
is
displayed
above
the waveform
display area to show the
storage locations
of both values.
nonvolatile
Key
This
key
selects which memory
to use.
The
selections
are
nonvolatile
memories
ml,
m?,
m3
and
m4. When
a
memory
is
turned on the
small
circle
below
the label i5 fuighlighted. The waveform
memories
are record
memories
that
store 8000
points
of
waveform
information in
each memory.
display
Key
This
key
toggles
the selected
waveform memory
display
on or off.
source Key
The
source key
selects the source
waveform
to
be stored. The
source
alternatives
ate any
channel or
either function.
store Key
This is
the active
key in the menu. By
pressing
this key
the specified
waveform
is
stored in
the specified
memory.
When
the
key
is
pressed
an
immediate
erase
of the selected
memory
and a
write
to the memory is
executed.
WaveforJ■
save Menu
10‐2
HP 54510A
Front‐
Panel Reference
圏
y司