Operating instructions

University of Saskatchewan
Electrical Engineering Laboratory Equipment Manual
( Standford Reasearch Systems, 2000 )
To reset the analyzer, to the default settings, hold down the < key when the
power is turned on. Continue holding the key down until the power-on tests are
completed. Wait 30 seconds between switching power off and on with any cathode ray
tube. Do not set the brightness higher then necessary.
The Auto Range key is used to set the attenuation on the input signal so that it
does not overload the analyzer input. The Auto Range key toggles the input range
mode between auto and manual. In manual mode, the input range is set in the Input
menu. The auto mode will display the input level indicator, on the display, in inverse
characters.
The frequency span is set in the Frequency menu. Pressing the Start Freq or
Center Freq, before the span is adjusted, locks these frequencies in. The Measure
menu is used to set the type of measurement, display, units and window.