Specifications

To use digital channels to view a signal
•
To configure the instrument quickly, press
Autoscale
.
•
To undo the effects of autoscale, press
Setup
, then press
Undo
Autoscale
.
•
To set the instrument to the factory-default measurement
configuration, press
Setup
, then press
Default Setup
.
Example Install grabbers on channels D0 and D1. Connect the probes for digital
channels D0 and D1 to the calibrator output on the front panel of the
instrument. Be sure to connect the ground lead. Set the instrument to
the factory default configuration by pressing
Setup
, then Default
Setup. Then press
Autoscale
. You should see a display similar to the
following.
HP 54645D Sample Autoscale Measurement
Figure 2-4
Front-Panel Overview
To use digital channels to view a signal
2-18