User`s guide

6 Sample Sessions: Other Mini-OTDR Modes How to Use the Fiber Break Locator
160 E6000C Mini-OTDR User’s Guide, E0302
How to View the Actual Measurement
Start measurement 8 Press Ok to start the measurement
NOTE If you want to return to the Multi Fiber Test Configuration
screen (Figure 57), select Config.
To abandon the measurement entirely, and return to the
EasyMode screen, press Close.
The fiber attached to your Mini-OTDR is measured for
each selected measurement setup. If you have not
specified any measurement setup, you see an error
message, and no measurements are performed.
Saved files Files are saved to the conventions explained in “How to
change the file name” on page 155.
You now see the message, Connect Fiber nnm and
press OK!, where nnm is the next fiber number
(incremented by 1).
Measure a new fiber 9 If you want to measure another fiber, connect the new
fiber to your Mini-OTDR, and select OK. If you do not
want to view any more fibers, select Close.
How to Use the Fiber Break
Locator
The Fiber Break Assistant
When you first start the Fiber Break Locator, you see a
message giving you hints on how to proceed. This is the
Fiber Break Assistant.