User`s guide

How to Use the Power Meter Submodule 6 Sample Sessions: Other Mini-OTDR Modes
E6000C Mini-OTDR User’s Guide, E0302
167
The display is now not updated, so you will not see any
new power levels.
Press Hold again to unfreeze the display.
How to Show the Power relative to a
Reference Value
Set Reference value Either
9 Select Disp/Ref from the left-hand screen. All
subsequent power levels are shown relative to the
current power level.
Or
♦ Select Set/Ref from the left-hand screen. Manually
input a reference value (see “How to change a
numerical setting” on page 132). All subsequent power
levels are shown relative to this value.
The power level is now shown relative to the Reference
value set. The Reference value is written after “Ref.” in
the Power Meter (left-hand) window.
NOTE If you reset the units (by selecting dB/W), the absolute
power level is shown again. To return to the relative
power level, select dB/W for a second time.
How to Send Code Modulated Output
Select Code mode 10 Cursor to the Source Mode (right-hand) diagram. Select
Mod., until you see the word “Code” in the Source
Mode window.
If the Power Meter detects the code, it switches to the
correct wavelength of the source, and you see LI in the
Power Meter window.