User`s guide

A Installation and Maintenance Initial Inspection
176 E6000C Mini-OTDR User’s Guide, E0302
Initial Inspection
Inspect the shipping container for damage. If there is
damage to the container or cushioning, keep them until
you have checked the contents of the shipment for
completeness and verified the instrument both
mechanically and electrically.
Performance Tests “Single-Mode/Multimode Module Performance Tests” on
page 219 gives a procedure for checking the operation of
the instrument. If the contents are incomplete,
mechanical damage or defect is apparent, or if an
instrument does not pass the operator’s checks, notify the
nearest Agilent Technologies office.
WARNING To avoid hazardous electrical shock, do not perform
electrical tests when there are signs of shipping damage
to any portion of the outer housing.
Internal Back-Up Battery
This instrument contains a lithium battery. Replacing the
battery should be carried out only by a qualified
electrician or by Agilent Technologies service personnel.
Battery replacement There is a danger of explosion if the battery is incorrectly
replaced. Replace only with the same or an equivalent
type (PANASONIC CR 2477). Discard used batteries
according to local regulations.