User`s guide

The Mini-OTDR module 1 Getting Started
E6000C Mini-OTDR User’s Guide, E0302
37
Remove module 3 Pull the module out of the module slot.
When the module has been fully removed, turn the
catches 90 degrees so that they are perpendicular to
the screen.
Inserting a Module
NOTE You should switch off your Mini-OTDR before inserting or
removing a module or submodule.
Module slot The slot in the back of the Mini-OTDR is used for the
various Mini-OTDR measurement modules. When you are
inserting or removing a module, open the connector
covers at the top of the module.
1 Open the connector covers
You can now see the Optical Output Connector where
fibers are attached and the module catches either side
of the module.
2 Make sure that the module catches run perpendicular
to the screen.
3 Lower the module into the module slot until you hear a
click.
4 Push the module further in, until you hear a second
click.
NOTE You should make sure that your module is fully
inserted into the module slot. If the module is not fully
inserted, this may affect the quality of your traces.