User`s guide

How to Run a Manual Measurement 3 Sample Sessions: Measuring a Trace

E6000C Mini-OTDR User’s Guide, E0302

bottom left of the screen. Press SELECT to bring up the

next page.

Optimize Mode 3 Move to <O

PTIMIZE MODE> and press SELECT. You see

three options: <S

TANDARD>, <RESOLUTION> and

YNAMIC>.

4 If you want to increase the dynamic range of the

measurement, move to <D

YNAMIC> and press SELECT.

5 Exit the Settings menu by selecting OK.

NOTE Parameters changed in the [S

ETTINGS] page only affect

subsequent traces. The current trace is unaltered.

The parameter values displayed on the Trace Screen

always refer to the current trace. Any parameter that has

been changed for subsequent traces is grayed.

NOTE If you alter the settings while a measurement is running,

press R

UN/STOP to start a new trace with the parameters

that you have just set.

How to Run the Measurement

Now that you have set the range correctly, the

measurement can be run:

1 Press the blue R

UN/STOP hardkey.

2 Wait for the trace to become free of noise. This takes

some seconds. Alternatively, wait until the

measurement time expires.

3 Press the R

UN/STOP hardkey.