User`s guide

3 Sample Sessions: Measuring a Trace How to Set the Horizontal Offset

96 E6000C Mini-OTDR User’s Guide, E0302

• The number of the Event at which the limit has been

exceeded (Relat. Evt. No.).

For Link Loss and Link Length (over the whole fiber),

this is the End Event.

Printout The Pass/Fail test table is also included in a printout. See

“How to Print the Measurement” on page 100.

NOTE If you want to perform a Pass/Fail test whenever a Scan

Trace is performed, select <A

UTO PASS/FAIL> from the

IEW] menu.

NOTE If you want to view the Pass/Fail test table, or to stop

viewing it, select <P

ASS/FAIL TABLE> from the [VIEW]

menu.

You cannot see the Pass/Fail test table and the Event

Table simultaneously. This means that selecting the Pass/

Fail test table deselects the Event Table, and vice versa.

How to Set the Horizontal Offset

You use the Horizontal Offset to set all distances (for

example the marker position, or locations in the Event

Table) relative to this point. You do this as follows.

Position marker 1 Move your marker to the point where you want to set

the offset.

If you want to precisely position the marker, press the

OWN Cursor to view around the marker.

2 Select the menu option [V

IEW]<SET H-OFFSET to A>