Operating instructions

Language Dictionary

Examples

PORT0 ON Set the port output high (logical 1)

CHAN 1;: PORT0 ON;:CHAN 2;:PORT0 OFF Set Channel 1 port high

and Channel 2 port low.

Query Syntax

PORT0?

Returned Parameters

<NR1> 1 for ON or 0 for OFF

Related Commands

None

RESistance Subsystem Channel-Specific Resistance Programming Function

Description

This subsystem programs the constant-resistance (CR) mode function of a single electronic

load or a single channel of a multiple electronic load. There is no SLEW command in this

subsystem. In the lowest resistance range the level changes in Volts/sec at the rate specified

by the present VOLT:SLEW command. The middle and high ranges change level in

Amps/sec at the rate specified by the present CURR:SLEW command.

Keywords

Command

RESistance[:LEVel][:IMMediate]

RESistance[:LEVel]:TRIGgered

RESistance:RANGe

RESistance:TLEVel

Function

Specify input resistance for CR mode.

Preset a new input resistance to be valid when a trigger occurs.

Specify full-scale input resistance range.

Specify input resistance used with TRANsient Subsystem.