Technical data

Figure 1.

1a Not used

1b USB connection

2a Not used

2b USB connection

3,4a Monitor connection

4b Serial port connection

5 Not used

6 Not used

9 Network connection

12a Power connection

12b Power On/Off switch

13 Compact Flash Drive

6. Power on the Agilent Instrument Controller and wait 5

minutes for initialization. The AIC will “beep” when

initialization is complete.

Configure the Agilent Instrument Controller Device

1. From the configuration computer (see Before You Start

section), open Internet Explorer and go to the address

http://192.168.1.1/iconsetup/login.aspx. If you have a

proxy server configured in Internet Explorer, you will need

to disable it.

2. Log in as Admin with no password. (Admin is case-

sensitive.)

3. On the General tab, enter the following information:

Name: for addressing the Agilent Instrument Controller

on the network

Location: physical location where the Agilent Instrument

Controller will operate

24 Installing AIC Revision A