Specifications

Customizing the System 53Chapter 3
Connecting Instrument Input(s) to the Measurement
Control Module
Depending on the device, connect the inputs to the UUT either through the
Measurement Control Module or directly through the mass interconnect.
Table 4-12 lists instrument connector cables to connect the instrumentation
inputs to the Agilent E6171 module. For additional information on cables
and connectors, refer to Chapter 4 on page 63
Table 3-1. MCM Module Cabling.
If connecting additional instrumentation to the MCM module, rows 13–16
on JI may be available. Optionally, if some of the factory default modules
are NOT included in your system, some of rows 1–12 may also be available.
E6171B
Connector Row
Instruments Cables to use for 6171B
Row 1 E1411 DVM
E3750-61603 - Grounds take up 2 middle posts, DVM on top.
Row 3 E1411 Current
Source
Row 5 E6173 Channel 1 E3750-61621
Row 7 E1563 Channel 1
Row 9 E1563 Channel 2 E6247-61601
Row 11 E1333 Channel 1
Row 12 E1333 Channel 2 E3750-61604
Row 20 Abus 1
E1072-61620 - From the E8792 Pin Matrix rows 20-23 in that
order.
Row 21 Abus 2
Row 22 Abus 3
Row 23 Abus 4
Row 24 Extriq jumper 1
E3750-61612 - From ICA IA rows 16-19, in that order.
Row 25 Extriq jumper 2
Row 26 Extriq jumper 3
Row 27 Extriq jumper 4
Row 30 E6174 Gate E3750-61604
Rows 31 Debug Trig E6170-61614 - From Debug Trig coax connection on monitor
rack mount
Row 32 Interlock E3750-61602
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com