Technical data

Testing Performance 3
16800 Series Portable Logic Analyzers Service Guide 27
Logic Analyzer Test Strategy
Only specified parameters are tested. Specifications are
listed on page 15. The test conditions defined in this
procedure ensure that the specified parameter is as good as
or better than specification. No attempt is made to
determine performance which is better than specification.
Not all channels of the logic analyzer will be tested; rather a
sample of channels is tested. The calibration laboratory may
choose to elaborate on these tests and test all channels at
their discretion.
To perform a complete test on a logic acquisition module,
start at the beginning of the chapter and follow each
procedure.
Test Interval
Test the performance of the module against specifications at
two- year intervals.
Test Record Description
For recording the results of each procedure, see
“Performance Test Record" on page 68.
Test Equipment
Each procedure lists the recommended test equipment. You
can use equipment that satisfies the specifications given.
However, the procedures are based on using the
recommended model or part number.
Instrument Warm-Up
Before testing the performance of the module, warm- up the
logic analyzer and the test equipment for 30 minutes.