User`s guide

segment. Limit lines are constructed from left to right. The segment is defined by its beginning
point (see Figure 5-6).
Note
Up to 20 segments can be specified for an upper or lower limit-line table.
When entering a limit-line segment, the frequency/time and amplitude values
will be listed as asterisks (***) until new values are entered. The new segment
will be listed last until both the frequency (or time) and the amplitude values
have been entered. Once the frequency/time and an amplitude value are
entered, the segment will be sorted into the limit-line table according to
frequency or time.
(-3 yyyfppp p y
4
REF .O dBm
ATT& lO\dB I I I
I I
I
CENTEP 300 MHz
# B’N
VBW 1 MHz
SPAN ZOO 0 MH7
SWP : !O msec
Figure 5-6. Limit-Line Segments
Item
Description of Items in Figure 5-6
1 Frequency and amplitude coordinate that starts the first segment.
2 First segment.
3 Frequency and amplitude coordinate that starts the second segment.
4 Second segment.
5 Frequency and amplitude coordinate that starts the third segment.
6
Third segment.
7
Frequency and amplitude coordinate that starts the fourth segment.
8 Fourth segment.
9
Frequency and amplitude coordinate that starts the fifth segment.
10 Fifth segment.
11 Frequency and amplitude coordinate that starts the sixth segment.
5-24 Using Analyzer Features