User`s guide

Figure 6-7. Plot Configure Menu
4. Turn on the spectrum analyzer and the plotter.
5. The plotter usually resides at device address 5. To configure the plotter address to 5 on the
spectrum analyzer, press:
@Giq
Press this key to access the configuration menu.
Plot Config
Press this key to access the plotter menu.
Plt Port Config
Press this key to access the plotter configuration menu.
PLT PORT RPIR PAR
(SO that HPIB is underlined)
PLOTTER ADDRESS
5
IHz)
6. Referring to Figure 6-7 select the plotter configuration for your spectrum analyzer by
pressing the appropriate keys:
p5iFiq Press this key to access the configuration menu.
Plot Config
Press this key to access the plotter configuration menu,
PLTS/PG 1 2 4
PLT Cl
LOC _
Press this key to underline the number of plots per page desired.
Choose 1, 2, or 4 plots per page (see Figure 6-2).
If two plots per page are chosen, this function allows you to select
the location on the paper for the plotter output. The upper and
lower sections of the softkey label graphically represent where the
plotter output will be located.
Press the softkey until the rectangular marker is in the desired
section of the softkey label.
PLT Cl-
LOC - -
If four plots per page are chosen, this function allows you to select
the location on the paper for the plotter output. The quadrant of
the softkey label graphically represents where the plotter output will
be located.
Press the softkey until the rectangular marker is in the desired
section of the softkey label.
COPY DEV PRNT PLT
Press this key so that PLT is underlined.
PLT->LJT ON OFF
Make sure that OFF is underlined unless you are plotting to a
laserjet.
Icopv)
Press this key to copy the spectrum analyzer display to the plotter.
6-8 Printing and Plotting