User`s guide

Change
Title
A prefix can be cleared with the clear function. Press (CONFIG] or (-1,
Change Prefix ,
YZ-# Spc Clear, Clear to clear the current prefix. The
current prefix is blanked by pressing DEFAULT CONFIG .
Front-Panel Key Access: C-1, I-j, (ml, or ISAVE)
allows you to write a 53-character screen title across the top of the screen.
The marker readout may interfere with the last 26 characters. The markers
can be turned off by pressing Ir\nKR), More 1 of 2 , and MARKER ALL OFF .
Pressing Change Title accesses the softkey menus that contain the available
characters and symbols. A programming command can be entered in the
screen title area. It can then be executed from the front panel by pressing
EXECUTE TITLE.
The screen title will remain on the screen until either Change Title is
pressed again or a trace is recalled that was saved with a screen title. A
screen title can also be cleared by using the clear function. Press (m),
Change Title,
YZ-# Spc Clear,
Clear to clear the current screen title.
Pressing Change Title accesses a menu containing the letters of the
alphabet, the underscore symbol (-), the number symbol (#), a space, and the
Clear softkey. To select a character, press the softkey that displays the group
of characters that contains the desired character. The softkey menu changes
to allow you to select an individual character. If you make a mistake, press
m to space back over the incorrect character. Additional characters are
available by pressing More 1 of 2 . Numbers may be selected by using the
numeric keypad.
Pressing RPG TITLE provides additional characters for the menu accessed
by pressing Change Title .
Pressing RPG TITLE provides lowercase letters,
numbers, Greek letters, and punctuation symbols. To access additional
characters, press RPG TITLE . When RPG TITLE is pressed, a character
table appears on the screen. To select a character, turn the knob to position
the cursor under the desired character and press the (ENTER] key. The step
keys move the cursor between rows. When all desired characters have been
entered, press WINDOWS (NEXT] or for an HP 859OL or an HP 8592L press
IHOLD). All other spectrum analyzer functions are inoperative until the CNEXT)
or [El key is pressed.
Front-Panel Key Access: (CAL) or (-1
CHANNEL
BANDWDTH
allows the user to enter the channel bandwidth to set up the spectrum
analyzer when using the measurement functions under the Power Menu
softkey. When the power measurements are first accessed the initial value for
channel bandwidth is 16 kHz. If the value is changed, the new value will be
saved through an instrument preset or power on. An error message will occur
for invalid values of channel bandwidth and channel spacing.
If one of the power measurements is active and the channel bandwidth is
changed, with PARAM AUTO selected, then the coupled spectrum analyzer
settings are immediately updated. If CONT MEAS is also selected, then another
sweet is taken and the measured results are uodated.
From-Panel Key Access: (-1
7-22 Key Descriptions