User`s guide

ERASE
MEM ALL
allows you to purge all user state registers, all user trace registers, all mode
registers, the editor buffer, Group delay normalization, all DLP memory, and
all microprocessor stack data. The stack pointer is set to its power-up value.
No system globals are erased and the calibration data is preserved. Pressing
ERASE MEM ALL causes a message to appear on the spectrum analyzer screen:
If youare sure,Press key againtopurgedata. Press ERASE MEM ALL
again if you want to dispose of all user memory. Press any other softkey if you
do not want to dispose of all user memory.
Note
ERASE MEN ALL ignores the state of the SAV LOCK. So, even if STATES and
TRACES are locked, they will still be erased by ERASE MEM ALL .
Front-Panel Key Access: C-1
ERASE
MEM CARD
allows you to dispose of any data or programs stored on the memory card by
formatting it. This is the same as FORMAT CARD . Pressing Dispose User Mem
and then pressing ERASE MEM CARD causes a message to appear on the
spectrum analyzer screen: If you are sure, Press key againtopurge data.
Press ERASE MEM CARD again if you want to dispose of the CARD’s memory.
Press any other softkey if you do not, want to dispose of the CARD’s memory.
Note
Use DELETE FILE to selectively delete stored programs or variables from
spectrum analyzer memory.
ERASE
STATEALL
Front-Panel Key Access: (75i%iYY]
allows you to purge all the user state registers 1 through 9. Pressing
Dispose User Mem and then pressing ERASE STATEALL causes a message to
appear on the spectrum analyzer screen: If you are sure, Press key again
to purge data. Press ERASE STATEALL again if you want to dispose of the
user state registers. Press any other softkey if you do not want to dispose of
user state registers.
Note
n If SAVE LOCK ON OFF is set to (ON), this function is disabled.
’ Use DELETE FILE to selectively delete stored programs or variables from
spectrum analyzer memory.
Front-Panel Key Access: [m]
7-40 Key Descriptions