User`s guide

highest, 7-80
signal tracking, 3-7, 7-63. See also marker
tracking
SINGLE FFT, 7-80
SINGLE MEAS, 7-80
single sweep, 7-79, 7-82
SLOPE, 5-26, 7-80
softkey label, 2-l
softkey locations, 8-l
softkey overview, 2-12
softkeys, 2-l
source power, 7-81
space
character, 7-92
span
0 Hz, 7-92
LAST SPAN, 7-49
window zone, 7-93
SPAN, 2-1, 2-13, 7-80
SPAN ZOOM, 3-9, 7-80
speaker, AM/FM demodulator
and quasi-peak detector (Option 103), 10-9
(Option 102), 10-9
SPEAKER ON OFF, 7-80
spectral density
channel power, 7-23
SPECTRUM ANALYZER, 7-80
spectrum analyzer attenuator, 7- 10
spectrum analyzer auto-coupled sweep time,
7-83
spectrum analyzer configuration
default, 7-31
spectrum analyzer error messages, 9-7
spectrum analyzer mode, 7-66
spectrum analyzer state recalled, 7-65
speed
data transmission, 7-12
split screen, 7-60
SQUELCH, 4-14, 7-81
SRC ATN MAN AUTO, 7-81
SRC PWR OFFSET, 7-81
SRC PWR ON OFF, 4-8, 7-81
SRC PWR STP SIZE, 7-81
SRQ, A-l
standard timebase, 7-14
start and stop frequencies, 7-53
START FREQ, 7-81
state of spectrum analyzer at power on, 7-65
state registers
locking, 7-74
STATE +
CARD, 7-82
STATE + INTRNL, 7-82
status byte, A-l
status byte definition, A-l
step keys, 2-3, 2-9
step size, center frequency, 7-21
step-size coupling, 7-10
stimulus-response measurements, 4-7
stimulus response mode, 7-83
STOP FREQ, 7-82
stop frequency, fft, 7-43
store correction factors, 7-14
storing
display, 7-35
storing the correction factors
CAL STORE, 1-9
STOR PWR ON UNITS, 7-2, 7-82
STP GAIN ZERO, 7-3, 7-82
STUVWX, 7-82
subtract display line from trace B, 7-11
subtract trace B from A, 7-5
SWEEP, 7-82
sweep control
continuous, 7-82
single, 7-79, 7-82
SWEEP CONT SGL, 7-82
SWEEP DELAY
gate utility, 7-83
sweep modes, 2-10, 2-11
SWEEP OUTPUT, 2-7
SWEEP RAMP, 7-3, 7-83
sweep time, 7-83
sweep time coupling, 7-10
gate utility, 7-30
SWEEP TIME DAC, 7-3, 7-83
SWEEP+TUNE OUTPUT, 2-6
sweep + tune output (Option 009), 10-5
switch trace A and B, 7-5
SWP CPLG SR SA, 4-9, 7-83
SWP TIME AUTO MAN, 7-83
SYNC CRD TV TRIG, 7-83
synchronization constants, 7-32
SYNC NRM NTSC, 7-84
SYNC NRM PAL, 7-84
T
table
of markers, 7-56
table of amplitude correction factors, 7-8
table of signal peaks, 7-63
TABLE ADL NRM, 7-85
temperature conditions, l-8
test set
500 transmission/reflection, lo-13
scalar 500 transmission/reflection, lo-13
TG UNLVL message, 4-12
third order intercept measurement, 4-39,
7-86
third-order intermodulation distortion, 3-22
Index-l 6