Technical data
21
86100A/B/C
Firmware Release Notes
86100A-Only Firmware Release Notes
A.03.01 Release Notes, February 15, 2002 (Differences from Release
A.02.20)
New Feature List
• Ability to acquire multiple channels at once in Eye Mode
• Ability to make measurement and mask analysis on multiple eyes at the same time
• Measurement results tab has a new look: clear meas button replaced by ?gx?h on meas
results tab and tab up/down button replaced by ?g?Þ?h on meas results tab
• Parametric mask creation
• Ohms/Division setting added for TDR mode
• Ability to annotate and delete individual measurements
• Add support for the following new modules: 86111U, 86111A, 86115B, 86113A, 86102A,
86103B, 86116A, 86107A, 83494A Options 103 and 107
Defects Fixed:
• When filter is turned on, autoscale switches filter when completed for no reason
• Trigger setting changes after autoscale
• System crash when non-TDR module is autoscaled in TDR mode
• Stop Menu item behaves as Stop/Single
• Source parameter is not being accepted with 'MEASure' subsystem commands
• Sending DISP:PERS INF in eye mode sets it to CGR
• Screen capture when in color grade saves files in grayscale
• Saving .jpg on full diskette results in 0 record length file
• Remote uploaded waveform memories are not stored on disk
• Remote command returns mainframe calibrated when it is not; added :CAL:REC
CHAn<N> command
• Quickmeasure attempts to measure waveform memories in eye mode
• Querying waveform values without waveform displayed hung the GUI
• Probe calibration hangs up box after remote command. We no longer initiate optical cal if
chan is electrical.
• Need more digits in read-out of X Markers at low time/div setting
• MTEST:START fails after running MTEST:LOAD on bad mask name, but displays no
warning
• MTEST:SAVE .msk saves as '.msk.pcm ? Measurement Results Tab drops in height when