User`s guide

1-72 Chapter1
System Verification and Performance Tests
Performance Tests
Crosstalk to Port 1 from 300 kHz to 3 GHz
1. Press Meas, Trans: REV S13 (A/R).
2. Press Sweep Setup, TRIGGER MENU, SINGLE.
3. Wait until the trace has settled.
4. Press Marker Fctn, MARKER SEARCH, SEARCH:MAX.
5. Write the marker value that appears on the analyzer display on the
performance test record.
6. If your analyzer does not have Option 006, proceed to “Port Crosstalk
(Port 2 and Port 3)” on page 1-74. If you have Option 006 in your
analyzer, continue with the following sections.
Crosstalk to Port 1 from 3 GHz to 6 GHz
1. Press Start, 3, G/n, Stop, 6, G/n.
2. Press Sweep Setup, TRIGGER MENU, SINGLE.
3. Wait until the trace has settled.
4. Press Marker Fctn, MARKER SEARCH, SEARCH:MAX.
5. Write the marker value that appears on the analyzer display on the
performance test record.
Crosstalk to Port 3 from 3 GHz to 6 GHz
1. Press Meas, TRANS:FWD S31 (B/R).
2. Press Sweep Setup, TRIGGER MENU, SINGLE.
3. Wait until the trace has settled.
4. Press Marker Fctn, MARKER SEARCH, SEARCH:MAX.
5. Write the marker value that appears on the analyzer display on the
performance test record.