User`s guide

1-106 Chapter1
System Verification and Performance Tests
Performance Tests
1. Connect the equipment as shown in Figure 1-50.
Figure 1-50 System Trace Noise Test Setup
2. Press Preset, 6, Power, 5, x1, Sweep Setup, NUMBER of POINTS, 51, x1.
3. Press Marker Fctn,MARKER MODE MENU, MKR STATS ON to activate the
instrument’s statistics feature.
4. Press Sweep Setup, CW FREQ, 3, G/n.
A/R Trace Noise Magnitude IF BW = 10 Hz
1. Press Avg, IF BW, 10, x1.
2. Press Meas, Trans:REV S13 (A/R).
3. Press Sweep Setup, TRIGGER MENU, SINGLE. Wait for the sweep to
finish as indicated by the Hld notation on the left side of the display.
4. Press Scale Ref, AUTO SCALE.
5. Write the s.dev (standard deviation) value shown that appears on the
analyzer display on the performance test record.