User`s guide

Chapter 2 2-9

Operation

The examples listed below should be used only as sample methods that

can be used when setting up and controlling the analyzer.

Example: Setting the Option H39 Mode Using the Front Panel

The Option H39 mode may be set up using the following front panel

menu selections:

1. To turn on the Option H39 mode, press System, CONFIGURE MENU,

OPTION HXX CONFIG

, and toggle the 3 PORT MODE key from off to ON.

2. To turn off the Option H39 mode, toggle the 3 PORT MODE key from on

to OFF.

Example: Setting the Port Selection Using the Front Panel

Set the Option H39 mode port selection from Port 1 to Port 3, from Port 2

to Port 3, and from Port 1 to Port 2 using the following front panel

selections:

1. Press Meas. The menu screen key SELECT PORTS [1-3] should be

shown after a preset, instrument power up, or when the 3 PORT mode

is ﬁrst turned on. “PORT 1–3” is the instrument default.

2. Press SELECT PORTS [1-3] once. The menu screen now shows

SELECT PORTS [2-3]. The S-parameters displayed are updated to

reﬂect Port 2 and Port 3. See Table 2-1 on page 2-8.

3. Press SELECT PORTS [2-3]. The menu screen now shows

SELECT PORTS [1-2]. The S-parameters displayed are updated to

reﬂect Port 1 and Port 2. See Table 2-1.

4. Press SELECT PORTS again to reset the Option H39 default settings.